DiMarzio Virtual Vintage Blues 2 Wiring Diagram

Dimarzio Virtual Vintage Blues 2 wiringDiscover a new world of tonal possibilities with a DiMarzio Virtual Vintage Blues 2.

This time around, we’re going to be doing a DiMarzio Virtual Vintage Blues 2 wiring for your guitar. The Blues 2 is a stacked humbucker that uses Alnico 2 magnets for a higher gain pickup that works just as well in the neck position as it does in the bridge. The Virtual Vintage Blues 2 is said to have a warm sound that does not become muddy, even when heavily distorted, making it an excellent choice for Metal or Blues. This pickup is installed using four colored conductor wires and a bare wire.

The Wires

The four colored wires are called “conductor” wires because each of them carries electricity to and from the two coils in the humbucker. Each coil needs to have one positive and one negative wire. The color that goes to each is what we call the pickup’s “Wiring Code.” Unfortunately, there is no standard Wiring Code, and the color combination varies between manufacturers and sometimes between different models of the same manufacturer.

The Bare wire is the pickup Shield. Its primary purpose is to trap radio frequencies, and other interferences that reach the pickup’s cover and shuttle them to ground before they penetrate to the coils and degrade your signal. The Shield and the pickup coils are not connected, but the Shield does get soldered to ground.

The Wiring Code

For the DiMarzio Virtual Vintage Blues 2, one coil uses Green and White while the other uses Red and Black. (Fig 1)

Fig 1


Humbucker coils are Series wired, which means that we run one coil right into the other to create one long continuous path for our signal to travel. Combining them makes the humbucker almost twice as loud as a single coil pickup, and it also helps give the humbucker its warmer tones due to phase cancellation caused by two coils in proximity of one another.

Getting Started

We begin our DiMarzio Virtual Vintage Blues 2 wiring by identifying the Red Wire as the Hot Wire. We solder the Black and White wires together and tape them off. Then finally, we use Green as the Ground Wire, and as standard practice, we solder the Green and Bare wires together. (Fig 2)

Fig 2


Now we are left with the positive (Red) and negative (Green) wires that will be needed to install our pickup. Solder the Green and the Bare wires to the back of the Volume pot, which is the standard place to solder all of the ground wires. (Fig 3)

Fig 3


Next, solder the Red wire to the first tab on the Volume control. Then solder the third tab to the back of the Volume pot, either with a short wire or by physically bending it until it contacts the casing of the potentiometer and can be soldered in place. (Fig 4)

Fig 4


Next, solder one wire from the center tab of the Volume pot to the Output jack. Then solder another wire from the Output jack to the back of the Volume control. (Fig 5)

Fig 5


Project complete!

Summary

This is the standard way to wire a humbucker pickup. If you want to add a Tone control, multi-pickup selector switch, etc., you will just be adding more components that will get soldered to the Volume control, but this primary circuit will not change. For example, if you have more than one pickup, all of the positive wires will go to the switch. The switch will decide which pickup signal will get sent to the Volume control, and from then on the circuit will be the same as presented here.

Click here for many other ways of wiring your pickups and opening up your tonal possibilities.

See you next time!