Coil Splitting Seymour Duncan Hot Rails Humbuckers with a Toggle Switch

coil splitting seymour duncan hot rails humbuckers with a toggle switchWith only a few tools and a little free time, splitting Seymour Duncan Hot Rails humbuckers with a toggle switch is a simple modification.

If you’re handy enough to install a toggle switch into the pickguard of your guitar, it’s often the easiest solution for coil splitting and many other modifications. Today we’re going to talk about coil splitting Seymour Duncan Hot Rails humbuckers with a toggle switch.

Seymour Duncan Hot Rails

The following guide will work with any humbucker; you just need to know which wires are which. If you know your exact pickup model, you can Google it to get the wiring code, but if your pickup is more obscure, you’ll need to use a digital voltmeter to get it.
In this guide, we’re going to talk about the Seymour Duncan Hot Rails specifically, so there’s no question about the wiring code.

Seymour Duncan Wiring Code

The Seymour Duncan humbucker contains four colored wires, and one bare wire, which is called the shield. These four colored wires correspond to the positive and negative of each coil.

  • The first coil uses the black wire as the starting and the white wire as the ending.
  • The second coil uses red as the starting and the green as the ending.

The standard way to wire up a humbucker is to run the first coil into the second. So we need to connect the white wire to the red wire. The shield wire gets connected to the ground wire, which in this case is green.

In most cases, the black wire will run to your pickup selector switch, and the green and bare wire, which are connected, will usually go to the back of the volume pot.

The Toggle Switch

When splitting Seymour Duncan Hot Rails with a toggle switch, almost any type of toggle switch will work. We recommend a two-position switch that has just on and off instead of a three-position switch. A three-position switch will leave you with two off positions, which is not very useful.

Split Pickup Modification

As we mentioned earlier, when using a Hot Rails humbucker, the black wire typically goes to the switch, and the green and bare wires go to the back of the volume control. This will not change.

Our modification only requires the use of the red and white wires that are already connected. You do not need to disconnect them to complete this mod.

Solder your switch as shown in Figure 1. Your toggle switch may have more or less lugs, but it will still solder the same way.

Fig 1


As you can see in Figure 1, we need to add a new ground wire from the switch to the back of the volume control. Now, when we flip our switch to split the pickup, a path is created between the red and white wires and ground.

This path essentially shorts out the second coil, resulting in a split pickup.

Conclusion

Splitting Seymour Duncan Hot Rails with a toggle switch is not very challenging, and it can really benefit you with some new tones. If you have more than one Seymour Duncan Hot Rails pickup, you can split them all the same way by adding a toggle switch and running a ground wire to the back of the volume pot.

If you can install toggle switches into the pickguard, or even the guitar body itself and make them look nice, you’re ahead of the game. We usually recommend using push-pull pots to split the humbuckers because you don’t need to make any permanent changes to the guitar. However, using toggle switches allows you to use those controls for other modifications down the line, and guitars with a lot of switches can look cool.

We hope you have enjoyed reading over this short how-to, and that it has helped answer any questions you have had on the subject of splitting your humbucker pickups. If you have any other questions, please send them in; we’d love to answer them all.

Please share this short guide to splitting Seymour Duncan Hot Rails with a toggle switch on Facebook and Twitter.

Leave a Reply

Your email address will not be published. Required fields are marked *